Saltar al contenido principal

Google Pixel 8 Pro スクリーンの交換

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 14 guías que incluyen este paso.

Inglés
Japonés

Traduciendo paso 21

Paso 21
Google Pixel 8 Pro Screen Replacement, Reassembly information: paso 0, imagen 1 de 3 Google Pixel 8 Pro Screen Replacement, Reassembly information: paso 0, imagen 2 de 3 Google Pixel 8 Pro Screen Replacement, Reassembly information: paso 0, imagen 3 de 3
Reassembly information
  • If you're installing a new screen with pre-installed adhesive, follow this step during reassembly. Otherwise, follow this guide to apply adhesive to your old screen.

  • Thoroughly check the entire screen for any plastic liners or tape and use the pull tabs to remove all of them. Look carefully for a large piece of plastic covering the back of the screen, a small one near the front camera cutout, and adhesive liners around the perimeter.

  • Reconnect the screen cable and reinstall its cover.

  • This is a good point to test your phone before sealing it up. Temporarily power on your phone and make sure it works as expected. Power it down before continuing.

  • Firmly press the screen into place on the frame—you should feel the clips "pop" into place.

  • Press firmly around the perimeter of the screen to secure it with the new adhesive.

  • Optionally, you can strengthen the adhesive bond by applying pressure evenly to the phone.

  • Follow this guide to calibrate the fingerprint sensor.

取り付ける新しいスクリーンに予め両面テープが貼り付けられている場合は、この手順に沿って作業を続けて下さい。スクリーンに両面テープが貼られていない場合は、こちらのガイドに従ってスクリーンに両面テープを貼って下さい。

プラスチックの剥離紙やテープ類がどこにあるか、スクリーン全体について確認してから、このタブを使ってそれらを全て取り除いて下さい。スクリーンの背面を覆う大きなプラスチック片やフロントカメラの切り欠きの近くにある小さなもの、及び縁周辺の接着剤の剥離紙は特に注意して確認して下さい。

スクリーンケーブルを接続し直して、スクリーンケーブルカバーも取り付け直して下さい。

スクリーンを接着する前に正しく機能するかどうか確認するなら、この時点で行いましょう。一時的に電源を入れ、正常に動作するか確認しましょう。組み立てを再開する前に、必ず電源を切りましょう。

スクリーンを筐体の正しい位置に合わせてからしっかり押し付けて下さい。クリップが正しい位置に収まる「ポンッ」という感触を感じるはずです。

スクリーンの端周辺をしっかり押し付けて、新しい両面テープをしっかり貼り付けます。

スクリーンをよりしっかり接着するためにデバイスの縁を均等に押さえつけることもできます。

こちらのガイドに従って指紋センサーのキャリブレーションを行って下さい。

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.