(1) Fully power down the device, and disconnect any external power (charger) (2) Open the kickstand, and locate the cover. Using a SIM ejector tool (or an unbent small paperclip), insert it into the hole and apply light pressure until the cover pops open. (3) With a Torx (T3) screwdriver, unscrew the SSD's retention screw. (4) Lift the SSD up gently, about 15-30 degrees, then pull it out towards you. (5) You may now send the drive to a reputable data recovery service, or attempt it yourself by using another PC in a compatible M.2 slot it has free, or by using an M.2 PCIe NVME enclosure.

One of these should help. I used it after my modem’s DC cable got gashed. Just use one of the compatible, included tips and set the power output to 12v. Hope I helped you out. If this did help please mark this as the accepted answer.

Yes, if you use the proper adhesives that meet or exceed the original adhesive. Your install job must be perfect or it’s water resisting abilities will be reduced or nullified.

A battery failure seems like the most likely problem. MacBooks do not turn on if the battery is damaged regardless of it being plugged in. You can order a Battery Fix Kit through iFixit (Linked Below) or have a repair shop replace it for you. MacBook Air 13" (Late 2010-2017) Battery If this helped please mark this as Solved.

I’m sorry to report this Ethan but when TouchID doesn’t work on 7 and newer phones, the home button gets disabled and AssistiveTouch gets turned on automatically. To restore functionality only Apple and select Best Buy stores have the right tools to make it work again. Apple has this tool called a Horizon Machine which pairs the home button to the logic board. Only Apple and some Best Buy stores have these.

You should manually pair the controller to the Xbox. Use this link to help you. https://support.xbox.com/en-US/xbox-360/accessories/connecting-game-controllers

Unplug the TV then wait about two hours for the components to discharge. Plug it in then it should work again.

Lens Errors are commonly caused by a jammed motor. Dust could've gotten inside the motor apparatus and jammed it. Clean out the motor and that should fix the error.

If I understand your question correctly, you are saying that upon turning on the phone it stops at the oneplus logo. I would recommend clearing the cache partition. This will not delete any of your data. To do so follow these steps. Power down the OnePlus 5 Boot the OnePlus 5 into Recovery Mode Tap on the language of your choice Tap on the Wipe Data and Cache option Tap on the Wipe Cache option Tap the Yes option when asked to confirm Wait for the OnePlus 5 to clear the cache partition Then tap on the Reboot option to restart the OnePlus 5

It could be a broken/damaged charging port. I would recommend replacing the charging port as a start.