Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Inglés
Español

Reemplazo del LCD en iPad Air LTE

Prerrequisitos de Guía

Todas las guías de pre-requisitos deben ser traducidas antes de que esta traducción se considere completa.

Calentamiento de iOpener

Reemplazo del panel frontal del iPad Air Wi-Fi

Información de Guía

= Hecho = Incompleto
    Replace a damaged or nonfunctioning LCD in an iPad Air LTE. [ … ] If your display is intact but your cover glass is damaged, refer to [guide|28607|this guide] instead. [ … ] Parts of this guide were shot with a Wi-Fi model and as such the internals may look slightly different from the LTE model. The procedure is the same for both models except where noted. [ … ] '''Warning: the battery isolation method in this guide is outdated, and may result in irreversible damage to the battery pins of the logic board, effectively destroying it. If you choose to isolate the battery this way, heed all warnings and work extremely carefully. If you choose to complete the guide without isolating the battery, avoid using metal tools except when completely necessary (like when removing screws) to prevent shorting the battery and damaging sensitive circuit components.'''
    Replace a damaged or nonfunctioning LCD in an iPad Air LTE. [ … ] If your display is intact but your cover glass is damaged, refer to [guide|28607|this guide] instead. [ … ] Parts of this guide were shot with a Wi-Fi model and as such the internals may look slightly different from the LTE model. The procedure is the same for both models except where noted. [ … ] '''Warning: the battery isolation method in this guide is outdated, and may result in irreversible damage to the battery pins of the logic board, effectively destroying it. If you choose to isolate the battery this way, heed all warnings and work extremely carefully. If you choose to complete the guide without isolating the battery, avoid using metal tools except when completely necessary (like when removing screws) to prevent shorting the battery and damaging sensitive circuit components.'''

      Describe la parte específica o el componente específico de este device en que estás trabajando. Ex: Batería

      Crear un título.

      Este breve resumen solo aparecerá en los resultados de búsqueda.

      Comunica información antes de que el lector empieze a leer la guía.

      Pasos de Guía

      Paso 1

      Quita cualquier cinta que oculte los tornillos del LCD.

      Paso 2

      Quita los cuatro tornillos Phillips que sujetan el LCD:

      Paso 3

      No intentes quitar completamente el LCD. Aún está conectado al iPad por varios cables en el lado del botón de inicio. Levanta sólo el lado del la cámara frontal.

      Paso 4

      Quita el único tornillo Phillips de 2.3 mm que sujeta el conector de la batería a la placa lógica.

      Paso 5

      Quita los tres tornillos Phillips de 1.4 mm que sujetan el soporte del cable de la pantalla.

      Paso 6

      Usa el extremo plano de un spudger para levantar suavemente el soporte del cable de la pantalla directamente desde la placa lógica.

      Paso 7

      Quita el LCD.

      Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.