Saltar al contenido principal
Alemán
Inglés
Paso 6
Remove screws Disconnect connectors for Lens assembly Carefully disconnect the tiny cable
Remove main PCB
  • Remove screws

  • Disconnect connectors for Lens assembly

  • Carefully disconnect the tiny cable

  • Next step is removing the PCB. I made the mistake not to take care about the battery compartment switch. If you are not careful, the black lever will break off. Not a problem though, because then the camera will work also with opened battery compartment

  • Remove main PCB by slightly bending outward the cover for the jack with fingernail. Now lift the PCB slightly upwards.

  • Look under the PCB, there is a connector that needs to be separated by means of a small screwdriver or spudger.

  • Re-attaching the connector is not easy. I used a small screwdriver to carefully press the connector back in place.

  • Note: This is not the official method to do this. Normally the Top cover and several other parts need to be removed too.

Remove screws

Disconnect connectors for Lens assembly

Carefully disconnect the tiny cable

Next step is removing the PCB. I made the mistake not to take care about the battery compartment switch. If you are not careful, the black lever will break off. Not a problem though, because then the camera will work also with opened battery compartmen

Remove main PCB by slightly bending outward the cover for the jack with fingernail. Now lift the PCB slightly upwards.

Look under the PCB, there is a connector that needs to be separated by means of a small screwdriver or spudger.

Re-attaching the connector is not easy. I used a small screwdriver to carefully press the connector back in place.

This is not the official method to do this. Normally the Top cover and several other parts need to be removed too.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.