Introducción

Before the majority of components can be accessed to be replaced, the back panel will need to come off.

Partes

No se requieren partes.

  1. Turn the laptop upside down.
    • Turn the laptop upside down.

    • Make sure the laptop is turned off.

    • Using the T5 Torx Screwdriver, remove the ten 3 mm long screws from the perimeter of the back of the laptop.

  2. Open up the information panel door (on the middle of the back side).
    • Open up the information panel door (on the middle of the back side).

    • While holding the door open, use the Phillips #00 Screwdriver to remove the two 10 mm long screws.

    • Carefully lift 2 corners of the back panel upwards, releasing the whole panel.

    • Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Brandon Schmidt

Miembro Desde 04/10/18

438 Reputación

3 Guías creadas

Equipo

UW Stout, Team S6-G1, Ogden Fall 2018 Miembro de UW Stout, Team S6-G1, Ogden Fall 2018

UWSTOUT-OGDEN-F18S6G1

4 Miembros

5 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 9

Últimos 7 Días: 56

Últimos 30 Días: 253

Todo El Tiempo: 279