Saltar al contenido principal

Este desmontaje no es una guía de reparación. Para reparar tu Sonicare Toothbrush HX6930, utiliza nuestros manuales de servicio .

  1. Sonicare Toothbrush HX6930 Teardown, Removing internals from toothbrush: paso 1, imagen 1 de 3 Sonicare Toothbrush HX6930 Teardown, Removing internals from toothbrush: paso 1, imagen 2 de 3 Sonicare Toothbrush HX6930 Teardown, Removing internals from toothbrush: paso 1, imagen 3 de 3
    • If the toothbrush has some slots in the bottom that will accept a large flat blade screwdriver, then clamp the screwdriver in a vise, engage the slots on the screwdrive and turn the case until you hear a snap. Then the internals can be pried out easily using a screwdriver. If no slot, use the excellent alternative opening procedure.

    • Have a look to an alternative opening procedure.

  2. Sonicare Toothbrush HX6930 Teardown: paso 2, imagen 1 de 3 Sonicare Toothbrush HX6930 Teardown: paso 2, imagen 2 de 3 Sonicare Toothbrush HX6930 Teardown: paso 2, imagen 3 de 3
    Herramienta utilizada en este paso:
    Desoldering Pump
    $3.99
    • Remove rubber ckt board cover & pull off the white cap at far left. Then unsolder wires at 6 points shown. While applying heat, extract solder with solder pump & solder wick. Gradually pry ckt board off the soldered points while applying heat. Then pull out the battery from the other side.

  3. Sonicare Toothbrush HX6930 Teardown: paso 3, imagen 1 de 3 Sonicare Toothbrush HX6930 Teardown: paso 3, imagen 2 de 3 Sonicare Toothbrush HX6930 Teardown: paso 3, imagen 3 de 3
    • Detach motor assembly from battery holder. Cut through the spot welds (A Dremel tool and abrasive disk is what I used) and open the clamshell holding the motor assembly. Pull out motor, remove magnet attached to motor stator. This concludes teardown process.

Greg

Miembro Desde 08/23/20

260 Reputación

2 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 4

Ultimos 7 días: 28

Ultimos 30 días: 53

Todo El Tiempo: 527