Saltar al contenido principal

LG G3 屏幕闪烁并老化

Información de Guía

= Hecho = Incompleto
Inglés
Chino
    1* Take# Remove the battary outbattery.
    2*Unscrew# Unfasten all screws and remove the whole backplastic cover.
    3*# You will se a connector down atsee connectors next to the chargercharging port take. Disconnect them off and you can blow some air to take the dirt off.
    4*# Take some paper and fold it 4 to 6 times (small one).
    5*# After folding it make sure it is the size of the connector that is next to the Camera.
    6*# Place the foldenfolded paper on top of the connector.
    7*# Slowly get back all the plastic covers.
    8*Screw# Put all screws back in all the screwsand fasten them.
    9*# Place the battarybattery, SD Card and the Sim back.
    10*# Power on the Phone.

    99.9% It will work.
    UPDATE:
    UPDATE:
    If you want to take it a step further ,
    get some thermal paste
    and remove the whole circuit board and but some on the spot (as shown on the picture) do NOT put too much a dot will be enough...
    after that you can go ahead an place the circuit board back in place, then place the paper on the connector(follow the steps 6-10)
    UPDATE:
    If you want to take it a step further, get some thermal paste and remove the whole circuit board and put some on the spot (as shown in the picture) do NOT put too much a dot will be enough...
    after that, you can go ahead and place the circuit board back in place, then place the paper on the connector(follow the steps 6-10)
    *Even thermal pad might do the job.
    Thanks,

    I hope this will fix the problem !

      Pasos de la guía

      Paso 1 — 把折叠纸放在这里!

      把纸放在这个连接器上!

      Paso 2 — 硅脂

      一个小的点会比填满更多的东西做得更好!

      Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.