Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 3 guías que incluyen este paso.
Traduciendo paso 1
Paso 1
-
Use the spudger to lift the retaining flap on the Zero Insertion Force (ZIF) tab securing the thick ribbon cable.
-
Slide out the ribbon cable using fingers or tweezers.
-
Using tweezers, disconnect the small ribbon cable below the flash assembly from the No Fuss Connector by simply pulling the ribbon cable straight out.
Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.