Samsung Galaxy Book Pro 360 15" Rear Case Replacement
Introducción
Ir al paso 1Use this guide to replace the rear case on your Galaxy Book Pro 360 15" laptop.
Before you begin, refer to the Samsung PC Repair Guide for safety information.
-
-
Close the screen and lay your laptop down with the rear case facing up to access the four rubber feet.
-
-
Herramienta utilizada en este paso:Tweezers$4.99
-
Insert an opening pick between the rear case and the rubber foot.
-
Pry up with the pick and dislodge the foot from the rear case.
-
Use tweezers or your fingers to remove the rubber foot.
-
Repeat this process on the remaining rubber feet.
-
-
-
Herramienta utilizada en este paso:Magnetic Project Mat$19.95
-
Use a Phillips screwdriver to remove the four 4.5 mm screws securing the rear case.
-
-
-
Apply a suction handle to the middle of the rear case's bottom edge, as close to the edge as possible.
-
Pull up on the handle with a strong, steady force to create a small gap between the rear case and the frame.
-
Insert an opening pick into the gap you created.
-
-
-
Slide the opening pick along the bottom edge to release the clips securing the rear case.
-
Continue sliding the pick along the perimeter of the laptop until all the clips securing the rear case have been released.
-
To reassemble your device, follow the instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Check out our Answers community for troubleshooting help.
To reassemble your device, follow the instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Check out our Answers community for troubleshooting help.
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.
