/
Mi Mesa de Trabajo

Obtén acceso rápido a guías, piezas y respuestas para tus dispositivos

DE
Deutsch
ES
Español
IT
Italiano
PT
Português
TR
Türkçe
JP
日本語
EN
English
FR
Français
NL
Nederlands
RU
Pусский
ZH
中文
KO
한국어
Unete
Iniciar sesión
Únete a la comunidad de reparación más grande del mundo
PartesGuíasRespuestas
Traducir
Retina MacBook 2015 Dual Microphone Assembly Replacement

Retina MacBook 2015 Dual Microphone Assembly Replacement

Geoff Wacker

Geoff Wacker y 4 otros contribuidores

Última actualización: March 20, 2023

Sin estimación
Moderado

Introducción

Ir al paso 1

Use this guide to replace the dual microphone assembly in your Retina MacBook 2015.

To avoid logic board damage, when your MacBook repair is complete but before powering it on, connect it to low-voltage power using a 5-Watt iPhone charger and a USB-C to USB-A cable. These accessories are not included with your MacBook, so make sure you have them ready before you begin.

Qué necesitas

Partes

Herramientas

Ver más…

  1. Retina MacBook 2015 Dual Microphone Assembly Replacement, Unfasten the lower case: paso 1, imagen 1 de 1
    Herramienta utilizada en este paso:
    Magnetic Project Mat
    $19.95
    Añadir a la cesta

    • Before proceeding, unplug and power down your MacBook. Close the display and flip it upside-down.

    • Remove the following eight screws securing the lower case:

    • Two 1.8 mm P5 Pentalobe screws

    • Four 2.9 mm P5 Pentalobe screws

    • Two 6.1 mm P5 Pentalobe screws

    • Note the orientation of the screws as you remove them—they need to be reinstalled at a slight angle.

    • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.

    Traducir

  2. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 2, imagen 1 de 3 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 2, imagen 2 de 3 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 2, imagen 3 de 3

    • Wedge your fingers between the upper case and the lower case, starting from the rear of the MacBook between the hinges.

    • Lift the lower case only slightly to avoid damaging the cables that connect the lower case to the upper case.

    • Keeping a firm grip, lift steadily until the lower case separates slightly from the upper case.

    • You may experience a lot of resistance when lifting the lower case. If necessary, slide an opening pick or other ESD-safe pry tool down the side edges of the lower case to pop the two hidden retaining clips free.

    • During reassembly, to re-engage the clips, press firmly near both side edges of the lower case (near where the pick is inserted in the third image) until you hear the clips snap into place.

    Traducir

  3. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 3, imagen 1 de 1

    • While holding the lower case in place, carefully flip the MacBook over so the Apple logo faces up.

    Traducir

  4. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 4, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 4, imagen 2 de 2

    • Lift the upper case and display together from the front edge and raise it to about a 45˚ angle.

    • It may be helpful to prop the MacBook open in this position for the next step.

    Traducir

  5. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 5, imagen 1 de 3 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 5, imagen 2 de 3 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 5, imagen 3 de 3

    • Use the flat end of a spudger to press and hold the small gold 'battery disconnect' button.

    • If the power LED is lit up, continue holding the button until the LED goes dark, and then release. This may take up to 10 seconds.

    • If the LED does not light, release the button after 5-10 seconds. Press and hold it again for 5-10 seconds, and release. Finally, press and hold it a third time for 5-10 seconds, and release.

    • This step ensures the MacBook is fully powered down and safe to work on.

    Traducir

  6. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 6, imagen 1 de 1

    • Close the MacBook and carefully flip it upside-down.

    Traducir

  7. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 7, imagen 1 de 1

    • Lifting from the front edge, open the lower case to an angle of about 45°.

    • Take care not to damage the ribbon cables that still attach the lower case to the MacBook.

    Traducir

  8. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 8, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 8, imagen 2 de 2
    Herramienta utilizada en este paso:
    Tweezers
    $4.99
    Añadir a la cesta

    • Use tweezers to peel back the tape covering the trackpad cable ZIF connector.

    Traducir

  10. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 9, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 9, imagen 2 de 2

    • Use a spudger to carefully flip up the retaining flap on the trackpad cable ZIF connector.

    Traducir

  11. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 10, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 10, imagen 2 de 2

    • Disconnect the trackpad ribbon cable from the trackpad by pulling it gently through its slot in the frame.

    Traducir

  12. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 11, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 11, imagen 2 de 2

    • Carefully turn the MacBook over, so that the lower case lays flat.

    • Raise the upper case/display assembly to about a 90° angle, and prop it up against something sturdy so you don't have to hold it.

    • Add a piece of tape near the track pad to secure the upper case and prevent accidental movement.

    • It's possible to open the MacBook all the way and lay both sides down flat, but this may damage the flex cables and is not recommended.

    Traducir

  13. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 12, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 12, imagen 2 de 2

    • Remove the single 2.9 mm T5 Torx screw securing the battery connector to the logic board.

    • 2015 models have a silver grounding clip with two foam pads directly under this screw, which may come loose. Be sure to reinstall it during reassembly.

    Traducir

  14. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 13, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 13, imagen 2 de 2
    Herramienta utilizada en este paso:
    Battery Blocker
    $3.99
    Añadir a la cesta

    • As an added precaution, you may physically disconnect the battery by inserting a battery isolation pick between the logic board and the battery connector.

    Traducir

  15. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 14, imagen 1 de 1

    • Remove the two screws securing the USB-C port cable bracket:

    • 1.1 mm Tri-point Y00 screw

    • Some variations of this model may use a Phillips #00 screw.

    • 3.5 mm T5 Torx screw

    Traducir

  16. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 15, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 15, imagen 2 de 2

    • Use the flat end of a spudger to disconnect the USB-C port cable bracket by prying it straight up from the logic board.

    • To reconnect this cable, first line up the metal bracket over the screw holes, then press down on the middle of the bracket. Make sure it's aligned correctly, or you may damage the connector.

    Traducir

  17. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 16, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 16, imagen 2 de 2

    • Use a spudger to flip open the retaining flap on the audio jack board cable ZIF connector.

    Traducir

  18. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 17, imagen 1 de 1

    • Disconnect the audio jack board ribbon cable by pulling it straight back out of the ZIF connector.

    • During reassembly, orient the ribbon cable so that the side with the white stripe faces you, as shown.

    Traducir

  19. Retina MacBook 2015 Dual Microphone Assembly Replacement, Audio Jack Board: paso 18, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement, Audio Jack Board: paso 18, imagen 2 de 2

    • Use a spudger to flip open the ZIF connector retaining flap for the dual microphone assembly ribbon cable.

    Traducir

  20. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 19, imagen 1 de 2 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 19, imagen 2 de 2

    • Disconnect the microphone assembly ribbon cable by pulling it straight out of its connector.

    Traducir

  21. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 20, imagen 1 de 1

    • Remove the two 3.2 mm T5 Torx screws securing the audio jack board to the case.

    Traducir

  22. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 21, imagen 1 de 1

    • Remove the audio jack board.

    Traducir

  23. Retina MacBook 2015 Dual Microphone Assembly Replacement, Dual Microphone Assembly: paso 22, imagen 1 de 1

    • Prepare an iOpener and apply heat to the upper case directly behind the microphone assembly.

    Traducir

  24. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 23, imagen 1 de 3 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 23, imagen 2 de 3 Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 23, imagen 3 de 3

    • Use a fine-tip probe or pick to gently peel the dual microphone assembly away from the case.

    Traducir

  25. Retina MacBook 2015 Dual Microphone Assembly Replacement: paso 24, imagen 1 de 1

    • Remove the dual microphone assembly.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order. To avoid logic board damage, when your MacBook repair is complete but before powering it on, connect it to low-voltage power using a 5-Watt iPhone charger and a USB-C to USB-A cable.

3 personas más completaron esta guía.

Autor

con 4 otros colaboradores

Geoff Wacker

Miembro Desde 09/30/13

91,070 Reputación

89 Guías creadas

Insignias: 44

+ 41 más insignias

3 comentarios

Hi! Anyone would know where to find the MacBook 2015 Dual Microphone only? iFixIt seems to have it listed already assembled with the MacBook Upper Part with Keyboard. It does not seem to list this part separately. Thanks!

Neo_Hunt - Contestar

Found the new mic assembly on ebay and amazon. Part 2243-A

Erick Luna - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 12

Ultimos 30 días: 24

Todo El Tiempo: 5,467