Saltar al contenido principal
Dell Inspiron 16 7610 Back Case Replacement

Dell Inspiron 16 7610 Back Case Replacement

Jerson Gomez

Jerson Gomez y 4 otros contribuidores

Última actualización: February 20, 2025

5 - 10 minutos
Fácil
Estudiante en Progreso

Introducción

Ir al paso 1

Follow this guide to remove the back case of your Dell Inspiron 16 7610 to access the internals of your laptop or replace it if it has broken or cracked.

Qué necesitas

Herramientas

  1. Dell Inspiron 16 7610 Back Case Replacement, Back Case: paso 1, imagen 1 de 2 Dell Inspiron 16 7610 Back Case Replacement, Back Case: paso 1, imagen 2 de 2
    • Flip the device over, so the backside is facing up.

    • Use a Phillips #00 screwdriver to remove four 4.00 mm screws.

    • Use the Phillips #00 screwdriver to unscrew or loosen two captive screws at the right and left corner near the hinges.

    • The last two screws should remain in the back case and can't be removed.

    • Three of the screws are dummy screws, only screwed into retainers. They are not holding anything in and can be left in place for simplicity.

    Only 6 screws have to be removed - the central one on the hinge area can remain.

    Bob Irving - Contestar

    As Bob noted in January, the top center screw doesn't do anything and doesn't need removing. As I found today during my repair, that is true but also the two bottom central screws are also unnecessary. If you check the photos in step 3, in the bottom of the battery near the screws circled in red, there are cutouts where the screws would go, but there is no mounting points on the bottom of the palmrest assembly where the screws go, so it was the case in the device photographed for this guide in the first place as well, the original guide author must simply not have noticed. (I did not notice at first, either, until reassembly found me questioning where the screws go.)

    I have edited this step to reflect as such. It also means if you lose one of the important screws accidentally, you have three replacements that aren't holding anything in that are good to go.

    Hope this helps.

    Justin Castle - Contestar

  2. Dell Inspiron 16 7610 Back Case Replacement: paso 2, imagen 1 de 1
    • -Use the opening tool between the seams of the top and bottom case to pry the back case off of the laptop.

    • Undo the clips gently as you pry the back of the device to avoid breaking them when removing the back case.

    • Remove the back case from the device.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Jerson Gomez

Miembro Desde 02/02/23

877 Reputación

3 Guías creadas

Equipo

Gateway, Team 1-3, Pee Spring 2023 Miembro de Gateway, Team 1-3, Pee Spring 2023

GCC-PEE-S23S1G3

4 Miembros

6 Guías creadas

Un comentario

Followed instructions. No clips broken but still cannot close the back cover. There’s a small gab in between the mouse and the cover when I close it.

Enos Nii Armah - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 4

Ultimos 7 días: 22

Ultimos 30 días: 40

Todo El Tiempo: 784