Canon PowerShot A2300 Back Cover Replacement

Nathan McMillan y 3 otros contribuidores

Última actualización: March 5, 2020

6 minuto

Fácil

Introducción

This guide will walk the user through the removal of the back cover for the purpose of replacement. In order to remove the back cover of the Canon PowerShot A2300 it is also necessary to remove the front cover.

Qué necesitas

Herramientas

Paso 1 Front Cover

Canon PowerShot A2300 Back Cover Replacement, Front Cover: paso 1, imagen 1 de 1

Open the A/V Out Digital port cover on the function button side to reveal a screw.

Traducir

Paso 2

Canon PowerShot A2300 Back Cover Replacement: paso 2, imagen 3 de 3

Remove all 6 screws(2.70 mm), 2 on each side and 2 on the bottom.
Screws are small and very easily lost.

Traducir

Paso 3

Open the card/battery latch by sliding the cover away from the camera in the direction indicated by the arrow.
Doing this gives a spot to grip on the bottom of the front cover. This will make it easier to handle when removing.

Traducir

Paso 4

Gently lift the bottom of the front cover to roughly a 30 degree angle.

Traducir

Paso 5

Pull the top of the front cover away from the camera by gripping the top of the front cover by the corners where the cover is still attached to the body.

Traducir

Paso 6 Back Cover

Canon PowerShot A2300 Back Cover Replacement, Back Cover: paso 6, imagen 1 de 1

Hold the camera in your hands with both thumbs on the screen with the screen faced up.
Keep close to the table top in case the camera falls out of your hands.

Traducir

Paso 7

Pull the the bottom left corner of the cover up about an inch to the point shown in the picture.
Do not completely remove the back cover by pulling on the side as shown. The cover is still attached on the top of the camera.

Traducir

Paso 8

Pry the top off by sliding the spudger under the On/Off button.

Traducir

Paso 9

Slide the cover to the right and off the camera.
Gently pry using the spudger on the right side if necessary.
The A/V OUT DIGITAL cover will sometimes become loose and disconnect from the cover