Versión actual por: Matt Zieminski

Título:

Texto:

I have a iRobot Roomba 620. I turned it on one day and it wheeled around in a big circle. After about 30 sec. it says, “error 10, spin wheels etc”. I did that, nothing. I order brand new wheels components, put them in, reset by holding down the “spot & dock” buttons.

I took the new wheels out again and I noticed both spun the same until I put them in. The left on is a bit stiffer. You can hear it too when the motor turns. The free-er one has a higher motor sound.

This is where I am stumped. Circuit board?

Dispositivo:

Estatus:

open

Respuesta Aceptada:

561076

Editado por: mayer (detalles del voto)

Título:

IRobot Roomba 620 wheel

Texto:

I have a iRobot Roomba 620. I turned it on one day and it wheeled around in a big circle. After about 30 sec. it says, “error 10, spin wheels etc”. I did that, nothing. I order brand new wheels components, put them in, reset by holding down the “spot & dock” buttons.

I took the new wheels out again and I noticed both spun the same until I put them in. The left on is a bit stiffer. You can hear it too when the motor turns. The free-er one has a higher motor sound.

This is where I am stumped. Circuit board?

Dispositivo:

Roomba

Estatus:

open

Respuesta Aceptada:

Editado por: oldturkey03

Título:

IRobot Roomba 620 wheel

Texto:

I have a iRobot Roomba 620. I turned it on one day and it wheeled around in a big circle. After about 30 sec. it says, “error 10, spin wheels etc”. I did that, nothing. I order brand new wheels components, put them in, reset by holding down the “spot & dock” buttons.

I took the new wheels out again and I noticed both spun the same until I put them in. The left on is a bit stiffer. You can hear it too when the motor turns. The free-er one has a higher motor sound.

This is where I am stumped. Circuit board?

Dispositivo:

Estatus:

open

Aporte original por: cbenish

Título:

IRobot Roomba 620 wheel

Texto:

I have a iRobot Roomba 620. I turned it on one day and it wheeled around in a big circle. After about 30 sec. it says, “error 10, spin wheels etc”. I did that, nothing. I order brand new wheels components, put them in, reset by holding down the “spot & dock” buttons.

I took the new wheels out again and I noticed both spun the same until I put them in. The left on is a bit stiffer. You can hear it too when the motor turns. The free-er one has a higher motor sound.

This is where I am stumped. Circuit board?

Dispositivo:

iRobot Roomba 630

Estatus:

open