Saltar al contenido principal

USB Board Enclosure Removal

Aviso: Ahora estás editando un requisito previo de la guía que estabas viendo. Cualquier cambio que realices afectará a todas las 4 guías que incluyen este paso.

Inglés
Español
Paso 3
USB Board Enclosure Removal, Remove the USB enclosure screws: paso 0, imagen 1 de 3 USB Board Enclosure Removal, Remove the USB enclosure screws: paso 0, imagen 2 de 3 USB Board Enclosure Removal, Remove the USB enclosure screws: paso 0, imagen 3 de 3
Remove the USB enclosure screws
  • Use a T8 Torx driver to remove the two 8.9 mm‑long screws securing the USB board enclosure:

  • One screw inside the shell

  • One screw on the bottom of the shell (where the base was)

Insertar traducción aquí

Insertar traducción aquí

Insertar traducción aquí

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.