Saltar al contenido principal

iPod Nano 4. Generation Logic Board Einheit austauschen

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 3 guías que incluyen este paso.

Inglés
Alemán
Paso 7
iPod Nano 4th Generation Logic Board Assembly Replacement: paso 0, imagen 1 de 1
  • Use a pair of tweezers to slide the click wheel ribbon cable out of its socket.

  • Before proceeding, be sure that both the click wheel ribbon cable socket and its cable are freed from the adhesive securing them to the dock connector and logic board.

  • Peel back the cable on both ends!

Schiebe das Flachbandkabel des Klickrads mit einer Pinzette aus seinem Sockel.

Bevor du fortfährst, musst du sicher sein, dass sowohl der Sockel des Flachbandkabels zum Klickrad als auch das Kabel nicht mehr am Dockanschluss und am Logic Board festkleben.

Löse das Kabel an beiden Enden ab!

-[* black] Use a pair of tweezers to slide the click wheel ribbon cable out of its socket.
+[* black] Use a pair of [product|IF145-020|tweezers] to slide the click wheel ribbon cable out of its socket.
[* icon_caution] Before proceeding, be sure that ***both*** the ***click wheel ribbon cable socket*** ''and'' ***its cable*** are freed from the adhesive securing them to the dock connector and logic board.
[* black] Peel back the cable on both ends!

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.