Saltar al contenido principal

여는 절차

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 9 guías que incluyen este paso.

Inglés
Coreano
Paso 7
Opening Procedure, Lift the display slightly: paso 0, imagen 1 de 3 Opening Procedure, Lift the display slightly: paso 0, imagen 2 de 3 Opening Procedure, Lift the display slightly: paso 0, imagen 3 de 3
Lift the display slightly
  • Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.

  • Insert an opening pick under the screen and the plastic bezel, not the screen itself.

  • The watertight adhesive holding the display in place is very strong; creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, apply more heat, and gently rock the screen up and down to weaken the adhesive until you create enough of a gap to insert your tool.

흡입 컵을 확실하고 일정한 압력으로 위로 당겨 전면 패널과 후면 케이스 사이에 약간의 틈을 만드세요.

스크린 자체가 아닌 스크린과 플라스틱 베젤 밑에 여는 픽을 끼우세요.

디스플레이를 제자리에 고정하는 방수 접착제는 매우 강합니다; 이 초기 틈을 만들려면 상당한 힘이 들어갑니다. 틈을 여는데 어려움을 겪고 있다면 더 많은 열을 가하고 여는 도구를 넣을 수 있을 만큼 틈이 생길 때까지 스크린을 위아래로 부드럽게 들었다 놨다하여 접착제를 약하게 만들어주십시오.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.