Saltar al contenido principal
iPhone 6 Plus Antenna Assembly Replacement

iPhone 6 Plus Antenna Assembly Replacement

Walter Galan

Walter Galan y 3 otros contribuidores

Última actualización: May 7, 2024

Sin estimación
Moderado
Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Introducción

Ir al paso 1

Prereq only, battery removed, rear camera removed, logic board will be removed.

Qué necesitas

Herramientas

Ver más…

  1. iPhone 6 Plus Antenna Assembly Replacement, Antenna Assembly: paso 1, imagen 1 de 1
    • Remove the following screws securing the antenna bracket to the rear case:

    • One 1.5 mm Phillips #00 screw

    • One 2.8 mm Phillips #00 screw

  2. iPhone 6 Plus Antenna Assembly Replacement: paso 2, imagen 1 de 1
    Herramienta utilizada en este paso:
    Tweezers
    $4.99
    • Grasp the antenna bracket with a pair of tweezers and lift it off the iPhone.

  3. iPhone 6 Plus Antenna Assembly Replacement: paso 3, imagen 1 de 1
    • Carefully pry the antenna connector up off the logic board with a plastic opening tool.

  4. iPhone 6 Plus Antenna Assembly Replacement: paso 4, imagen 1 de 2 iPhone 6 Plus Antenna Assembly Replacement: paso 4, imagen 2 de 2
    • Grasp the antenna connector with a pair of tweezers and gently lift it from its retaining clip on the logic board.

  5. iPhone 6 Plus Antenna Assembly Replacement: paso 5, imagen 1 de 2 iPhone 6 Plus Antenna Assembly Replacement: paso 5, imagen 2 de 2
    • The two connectors may be coupled by a single adhesive tab. If this is the case, then they may detach as a pair.

    • Disconnect the power button cable and audio control cable connectors from their respective sockets on the logic board.

  6. iPhone 6 Plus Antenna Assembly Replacement: paso 6, imagen 1 de 1
    • Remove the following screws securing the top cellular antenna to the rear case:

    • One 2.8 mm Phillips #00 screw

    • Two 1.6 mm Phillips #00 screws

  7. iPhone 6 Plus Antenna Assembly Replacement: paso 7, imagen 1 de 2 iPhone 6 Plus Antenna Assembly Replacement: paso 7, imagen 2 de 2
    • Use a pair of tweezers to grasp and remove the top cellular antenna out of the iPhone.

    • During reassembly, make sure to place the small washer in the top left corner of the antenna assembly.

Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 2

Todo El Tiempo: 679