Paso Companion XP450 LED 360º Lantern Teardown Historial #3

	[title] Button Case
	[* black] The shell of the button mechanism sits on top of the battery.The external button is made of rubber, and is glow in the dark. The rubber was removed with a pair of tweezers
	[* black] The internal structure of the button was a plastic frame which supported the actual button mechanism. This was also removed using tweezers.
-	[* black] The grey casing was ~~separated from~~ the ~~battery frame using~~ force, as ~~there~~ were ~~no screws or anything~~ of the ~~sort~~
+	[* black] The grey casing was harder to separate as it was not connected to the body with any fasteners, so I had to remove it by force. It had 2 nuts and bolts but I was unable to move them, as they were connected to the top of the lamp.
	[* black] Inside the casing was a PCB connected to the button and the component above, possibly the LED light.
-	[* black] The button board which the green rubber sat ~~on had~~ a small red ~~light translucent~~ plastic ~~panel under~~ to ~~indicate if the light is switched on/charged~~.
+	[* black] The button board which the green rubber sat was obscured with a small plastic frame to hold it in place. The red plastic filament was delicate and had to be separated carefully by hand.
	[* black] Weight: 14 g
	[* black] Height: 80 mm
	[* black] Diameter: 130 mm