Cambios al paso #1
Editado por Sarah Westberg —
Edicion aprobada por Sarah Westberg
- Antes
- Después
- Sin cambios
Líneas de Paso
| [* black] Heat the soldering iron to middle high heat. | |
| - | [* black] Once the soldering iron is fully heated, inject a small amount of flux onto the LED solder connection you wish to replace. |
| + | [* icon_caution] The soldering iron can burn when heated. Use caution when using. For more information on using a soldering iron, take a look at [guide|750|How to Solder and Desolder Connections|new_window=true] |
| + | [* black] Inject a small amount of flux onto the LED solder connection you wish to replace. |
| [* black] Place the solder wick on top of the solder joint. | |
| [* black] Press the soldering iron on top of the solder wick on top of the solder joint, and press until you see the solder come through the wick. | |
| - | |
| - | [* |
| - | |
| + | [* black] Once you see the solder through the wick (it should look silver and not copper colored) pull the wick off the solder joint and remove the soldering iron. |
| + | [* icon_note] Repeat on the 3 other solder joints for the LED. |
| + | [* black] Remove the LED with tweezers. |