Cambios al paso #35
Líneas de Paso
| [* black] By gently pulling apart the front and back halves of the lens module assembly, we expose a black gear and white gear connecting the larger brass gear to the motor | |
| - | [* black] Using tweezers it's possible to remove the black gear without fully opening the lens module halves - just open wide enough like shown here to gain access. |
| + | [* black] Using [product|IF145-020|tweezers] it's possible to remove the black gear without fully opening the lens module halves - just open wide enough like shown here to gain access. |
| [* icon_caution] Note: the flex circuits around the lens module are soldered and cannot be removed. Therefore you need to gently carefully move them aside when pulling apart the lens module. | |
| [* icon_caution] On the right side of the photo, there's a small plastic piece with flex circuit attached. This piece is held by one of the screws and the front/back halves of the lens module. When reassembling it's a bit fiddly to get back in the right place if you're not paying attention. |