Introducción

How to prep a black wire for XYZ job.

Partes

No se requieren partes.

  1. Locate QCPN#10669 which is a black hookup wire.
    • Locate QCPN#10669 which is a black hookup wire.

  2. Measure out a 10cm length of wire. Use a pair of flash cutters to carefully cut through the wire. Caution: the wire must be no longer than 10.5cm and no shorter than 9.5cm in length.
    • Measure out a 10cm length of wire.

    • Use a pair of flash cutters to carefully cut through the wire.

    • Caution: the wire must be no longer than 10.5cm and no shorter than 9.5cm in length.

  3. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda

    ¿Alguna vez arreglaste algo? Eso es genial.

    Comparte tu historia de reparación con #SoyUnGenio

    Todos somos Genios

    Comparte tu historia de reparación con #SoyUnGenio

  4. Your wire should look like this now. #testedit
    • Your wire should look like this now. #testedit

  5. Measure 20mm from either end of the wire. With the flash cutters remove the instulation that is covering the wire.
    • Measure 20mm from either end of the wire.

    • With the flash cutters remove the instulation that is covering the wire.

    • Be careful not to cut to deep because you will damage the wire strands inside.

  6. Measure 10mm from the other side of the wire. Remove the insulation from the wire with a pair of flash cutters.
    • Measure 10mm from the other side of the wire.

    • Remove the insulation from the wire with a pair of flash cutters.

  7. Your finished wire should now look like this.
    • Your finished wire should now look like this.

    • Remember to twist of the ends of the wire with your fingers so that the wire strands are not loose.

Conclusión

You are finished.

5 personas más completaron esta guía.

Russell Frampton

Miembro Desde 30/07/13

329 Reputación

1 Guía escrita

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 275