Saltar al contenido principal

Fugoo Tough XL Case Replacement

Qué necesitas

  1. Fugoo Tough XL Case Replacement, Case: paso 1, imagen 1 de 1
    • Remove the four 3 mm screws located in each corner using a 3 mm Hex screwdriver.

  2. Fugoo Tough XL Case Replacement: paso 2, imagen 1 de 2 Fugoo Tough XL Case Replacement: paso 2, imagen 2 de 2
    • Gently pull up and off the outer casing.

    • Do not feel afraid to use a bit of force if necessary.

  3. Fugoo Tough XL Case Replacement: paso 3, imagen 1 de 2 Fugoo Tough XL Case Replacement: paso 3, imagen 2 de 2
    • Remove the internal device from the outer casing.

    • Remove the four 12 mm screws on each corner using a T10 Torx screwdriver.

    • Remove the eight 6 mm screws on the top and bottom using a T10 Torx screwdriver.

  4. Fugoo Tough XL Case Replacement: paso 4, imagen 1 de 3 Fugoo Tough XL Case Replacement: paso 4, imagen 2 de 3 Fugoo Tough XL Case Replacement: paso 4, imagen 3 de 3
    • Use your hands to gently remove the side plates.

    • Use an opening tool to pry off the back plate with the Fugoo trademark.

  5. Fugoo Tough XL Case Replacement: paso 5, imagen 1 de 1
    • Slowly pull the front casing from the back casing. Avoid putting any tension on the connected cables.

    • Separate the two slowly and consistently to avoid damaging the speaker cables.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Abdul

Miembro Desde 02/17/17

527 Reputación

4 Guías creadas

Equipo

USF Tampa, Team S19-G1, Hoffman Spring 2017 Miembro de USF Tampa, Team S19-G1, Hoffman Spring 2017

USFT-HOFFMAN-S17S19G1

4 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 8

Todo El Tiempo: 941