Disassembling Arnova 7K G3 Motherboard

Kue y 4 otros contribuidores

Última actualización: February 26, 2020

20 - 30 minutos

Moderado

Fotos de acción

Bordeador de Pasos

Introducción

Ir al paso 1

The logic board is an essential part of an electronic device. Removing the board is a significant step while accessing or removing some components of the device. This guide shows you how to accomplish this task.

Qué necesitas

Herramientas

Paso 1 Rear Cover

Disassembling Arnova 7K G3 Motherboard, Rear Cover: paso 1, imagen 1 de 3

Disassembling Arnova 7K G3 Motherboard, Rear Cover: paso 1, imagen 2 de 3

Disassembling Arnova 7K G3 Motherboard, Rear Cover: paso 1, imagen 3 de 3

Remove four 5 mm Phillips #00 screws from each corner of the tablet.

Traducir

Paso 2

Place the iFixit opening tool in the notches between the cases and pull the covers apart.

Traducir

Paso 3

Repeat step two until 3/4 of the rear cover is unlatched.
Proceed to remove the rear cover by gently pulling it apart by hand.

Traducir

Paso 4 Disassembling Arnova 7K G3 Logic Board Ribbon Connectors

Disassembling Arnova 7K G3 Motherboard, Disassembling Arnova 7K G3 Logic Board Ribbon Connectors: paso 4, imagen 1 de 2

Disassembling Arnova 7K G3 Motherboard, Disassembling Arnova 7K G3 Logic Board Ribbon Connectors: paso 4, imagen 2 de 2

Herramienta utilizada en este paso:

Tweezers

$4.99

Añadir a la cesta

Peel the copper tape covering the ribbon connector with a set of tweezers.

Traducir

Paso 5

Disassembling Arnova 7K G3 Motherboard: paso 5, imagen 3 de 3

Locate the two gray pins on the ribbon connector.
Grab the first pin with tweezers and gently pull it towards the ribbon. Repeat the step.
Gently pull the ribbon cable out of the connection port.

Traducir

Paso 6

Disassembling Arnova 7K G3 Motherboard: paso 6, imagen 3 de 3

Locate the ribbon connector two.
Locate the pins of ribbon connector two. Repeat step two for unlocking the pins.
Gently pull the ribbon out of the connection port.