Canon Powershot A70 Front Exterior Panel Replacement

Brian y 14 otros contribuidores

Última actualización: January 3, 2024

15 minuto

Fácil

Necesita mejores imágenes

Introducción

Ir al paso 1

Use this guide to replace a Canon Powershot A70 Front Exterior Panel. The front exterior panel is used as an outside casing for the wiring of the camera. Before starting the guide, make sure you remove the camera's batteries.

Qué necesitas

Herramientas

Paso 1 Shutter/Speaker Panel

Canon Powershot A70 Front Exterior Panel Replacement, Shutter/Speaker Panel: paso 1, imagen 1 de 1

Open the battery compartment and remove the batteries.
Remove the two screws that are deep in the battery compartment with a Phillips #00 screwdriver.

Editar

Paso 2

Open the CF compartment and remove the top screw with a Phillips #00 screwdriver.
The panel that holds the shutter button and zoom will come off.
Be careful! There are two small wires connecting the speaker to the body of the camera. These are very delicate so proceed with caution. Do not remove.

Editar

Paso 3 Rear Exterior Panel

Canon Powershot A70 Front Exterior Panel Replacement, Rear Exterior Panel: paso 3, imagen 1 de 1

Unscrew the three small screws on the bottom of the camera with a Phillips #00 screwdriver.
Remove the wrist strap.

Editar

Paso 4

Remove the screw in the CF compartment with a Phillips #00 screwdriver.

Editar

Paso 5

Canon Powershot A70 Front Exterior Panel Replacement: paso 5, imagen 3 de 3

Open the rubber Digital AV Out compartment flap.
Pry the battery with an opening tool.
Carefully pull out the battery with two fingers.
Remove the two screws that are now visible with a Phillips #00 screwdriver.

Editar

Paso 6

Starting from the bottom, carefully pull the casing off.
The casing will now pivot at the top.
There are three catches that hold the back casing to the body.
You may have to pull with some force. The rear panel will make a snapping noise when it separates from the body.