Canon PowerShot SD1400 IS Screen Replacement

Última actualización: May 7, 2018

15 - 30 minutos

Moderado

Introducción

Screens can be cracked and broken or stop working completely. This guide will show how to replace the screen in the device.

Qué necesitas

Partes

Canon PowerShot SD1400 IS screen
Enlace de afiliado
Disponible en venta en Amazon
Ver

Herramientas

iFixit gana una comisión si finalizas una compra usando estos enlaces.

Paso 1 Screen

Canon PowerShot SD1400 IS Screen Replacement, Screen: paso 1, imagen 1 de 3

Canon PowerShot SD1400 IS Screen Replacement, Screen: paso 1, imagen 2 de 3

Canon PowerShot SD1400 IS Screen Replacement, Screen: paso 1, imagen 3 de 3

Remove the 2.0 mm Phillips screws on both sides of the camera using the Phillips #00 screwdriver.
There will be 4 total screws that need to be removed, 2 on each side.

Editar

Paso 2

Remove the 4.0 mm Phillips screw located on the bottom of the camera.

Editar

Paso 3

Remove the front face panel of the camera.
The face can be removed by hand with a firm pressure. If one point of the face is stuck to the body, ensure that there is not a screw remaining at that position to hold it in place.

Editar

Paso 4

Remove the rear panel of the camera.

Editar

Paso 5

Remove the panel of buttons by hand.

Editar

Paso 6

Remove the 3.0 mm Phillips copper colored screw from the top of the camera.

Editar

Paso 7

Remove the 3.0 mm Phillips silver screw from the rear face of the camera, located on the upper right corner.

Editar

Paso 8

Using the plastic spudger, pry the golden film on the front face of the camera off of the microchip.
Once removed, a silver screw will be visible from underneath the golden film.

Editar

Paso 9

Remove the 3.0 mm Phillips silver screw using the screwdriver.

Editar

Paso 10

Using the metal spudger, carefully pry the small black tab away from the brown film end of the golden film.
Once released, the small black tab will point straight away from the front face of the camera.
After releasing the tab, the golden film will no longer be secured to the front face of the camera.

Editar

Paso 11

Unplug the small chip from the face of the camera by carefully inserting the metal spudger underneath the cluster of red wires visible. Then lift the cluster of wires upwards, parallel to the front face of the camera.

Editar

Paso 12

You can now remove the top panel from the camera using your hands with firm pressure.

Editar

Paso 13

Insert the metal spudger underneath the golden film on the front face
Lift the golden film on the front face of the camera up and away from its connection

Editar