Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

This guide teaches how to to install the back panel latch on your camera.

  1. Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
    • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

  2. Using your finger, peel back the textured grip so the components are separated. Using your finger, peel back the textured grip so the components are separated.
    • Using your finger, peel back the textured grip so the components are separated.

  3. Using the flat end of a spudger, loosen the connection between the front panel and the device. Remove the front panel using your hands. Remove the front panel using your hands.
    • Using the flat end of a spudger, loosen the connection between the front panel and the device.

    • Remove the front panel using your hands.

  4. Using a 00 Phillips screw driver, unscrew the two screws located on the side of the camera.
    • Using a 00 Phillips screw driver, unscrew the two screws located on the side of the camera.

    • Two 4.3 mm Phillips screws

  5. Open the back panel by pushing the locking latch up.
    • Open the back panel by pushing the locking latch up.

    • Lift the latch cover off of the camera body.

  6. Slide the side latch (for the back door) up and then lift straight away from the camera body.
    • Slide the side latch (for the back door) up and then lift straight away from the camera body.

    • Sometimes the latch will detach while pushing it up.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Zach

Miembro Desde 04/04/12

43 Reputación

8 Guías creadas

Equipo

Cal Poly, Team 14-9, Forte Spring 2012 Miembro de Cal Poly, Team 14-9, Forte Spring 2012

CPSU-FORTE-S12S14G9

5 Miembros

24 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 10

Todo El Tiempo: 2,023