Saltar al contenido principal

Introducción

In this guide we show you how to remove and replace a broken or defective display on your Huawei P10 Plus smartphone.

If the screen is broken you might want to protect your eyes from glass shreds and get a better grip to open the phone by applying some tape onto the screen.

If your replacement part does not come with adhesive mounted on it, you will also need to purchase new adhesive.

  1. Use an iOpener to loosen the adhesive beneath the display, focusing on the upper and lower part of the display. Use an opening pick, or iFlex, to separate the adhesive on all sides of the display. To avoid damage to the display, do not push the tool too deeply into the phone.
    • Use an iOpener to loosen the adhesive beneath the display, focusing on the upper and lower part of the display.

    • Use an opening pick, or iFlex, to separate the adhesive on all sides of the display.

    • To avoid damage to the display, do not push the tool too deeply into the phone.

  2. There is a thin display cable between the screen and phone, be very careful not to rip it when opening the device. Place a suction cup, or iSclack, on the upper portion of the phone and lift the display off the midframe. Don't remove the display, the cable is trapped under a bracket screwed to the phone. You can flip the display to lay it down without straining the cable, or simply hold it in the next steps.
    • There is a thin display cable between the screen and phone, be very careful not to rip it when opening the device.

    • Place a suction cup, or iSclack, on the upper portion of the phone and lift the display off the midframe.

    • Don't remove the display, the cable is trapped under a bracket screwed to the phone. You can flip the display to lay it down without straining the cable, or simply hold it in the next steps.

  3. Remove the 3.3 mm-long Phillips screw securing the display flex connector bracket.
    • Remove the 3.3 mm-long Phillips screw securing the display flex connector bracket.

    • Open the metal bracket that covers the display flex cable.

    • Use a spudger to disconnect the display flex cable.

    • Remove the display.

    • When reassembling your phone replace old adhesive with double-sided tape or pre-cut adhesive strips.

Conclusión

To reassemble your device, follow these instructions in reverse order.

7 personas más completaron esta guía.

Tobias Isakeit

Miembro Desde 31/03/14

89,126 Reputación

166 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

137 Miembros

16,708 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 4

Ultimos 7 días: 27

Ultimos 30 días: 114

Todo El Tiempo: 10,909