Wiki con Contribuciónes de Estudiantes
Un estudiante impresionante de nuestro programa de educación escribió este wiki. No está administrado por el personal de iFixit.
GE Digital Messaging System Troubleshooting
GE Digital Messaging System is an answering system connected to any phone line.
- I Can't Hear My Messages
- I Can't Restart My Messages
- Incoming Messages are Incomplete
- Device Won't Respond to Remote Control Commands
- My Message Counter is Flashing Rapidly
I Can't Hear My Messages ¶
Adjust the volume control ¶
The volume control is located on the right side of the face on the device. Press the up button.
Replace the Speaker ¶
If adjusting the volume does not work the speaker may need to be replaced. Here is how to replace the speaker
I Can't Restart My Messages ¶
You must play messages for at least five seconds ¶
You must play messages for at least five seconds before pressing and holding the previous button to restart messages. This is located on the face of the device.
Incoming Messages are Incomplete ¶
Message may be too long ¶
The caller may have left a message longer then the message length you chose during setup.
Memory may be full ¶
If the device's memory is full, delete some of your messages.
Accidentally pressed the STOP/SET button ¶
You may have accidentally pressed the STOP/SET button when you were playing back your messages.
Device Won't Respond to Remote Control Commands ¶
Are you using a touch-tone phone? ¶
You must use touch-tone phone which is also known as a push button phone.
Security Code ¶
You must enter the correct security code.
Did the unit hang up? ¶
If you take no action for a period of time, the system automatically hangs up.
My Message Counter is Flashing Rapidly ¶
Memory is full ¶
Memory is Full. Erase some of your messages.