Joshua Freeman

So I was looking to see why the door latch was not closing tightly over the ice chute of my ice dispenser on the front of...

For the past year our ice maker has been making icicles and dripping water on the food in the freezer. I just took the ice...

I have an original game boy that when turned on, the LED is red and you can hear whatever game is inserted, but no visual...

Contact customer support https://shop.bt.com/Help

Sounds like it's time to get another DS. I don't think the bottom will work without the top. You can find used DS and DS lites pretty cheap on eBay or you local Facebook marketplace.

The company closed. I think you’re out of luck. You may have to look into replacing the power system all together. Or buy another electric board.

You should contact maytag and set up a time for them to come take a look at it. https://www.servicebench.com/servicebenc...

Here is a list of all service centers in the United States https://www.service-center-locator.com/texas-instruments/texas-instruments-service-center.htm

Ashley, There may be a loose connection inside the train or the batteries may not be making contact with the train to power it up. The worse case scenario is that one of the components on the circuit board malfunctioned or overheated and may need replaced. First, take a look at the battery compartment. Make sure that all of the metal is shiny and clean. Any type of debris or rust can block the batteries from powering the toy. Also make sure that the batteries are not loose, they need to be snug and secure. If you can provide some pictures of the toy, that would be helpful to look at and diagnose. The next step would be to remove the screws and open the toy train up to look inside. If you decide to do this, post some pictures of the insides and we can look to see if anything doesn’t look right.

Here it is on Amazon.com

Is your part in question in one of these pictures? If not, can you find a picture or post a picture so we can see what you are referring to?

Use some glass cleaner to clean the contacts on the board with a soft cloth. Also clean where the joystick contacts the board. It sounds like there could be something on the board that is causing the controller to signal moving to the right.

This would happen to our flip phone, but a much older model. I would by the same model for parts and swap the pieces that I needed. Usually found my replacements on eBay. If it's out of warranty, that would be the easiest thing to do.