Reputación con el tiempo
Análisis de Reputación
Evento | Recuento | Delta |
---|---|---|
El mensaje fue votado positivamente | 1238 | 14664 |
Respuesta aceptada | 369 | 10774 |
Alguien completó tu guía | 141 | 496 |
A alguien le gustó tu guía | 115 | 236 |
Respuesta Aceptada | 2 | 18 |
Publicar contenido actualizado que contiene un enlace a tu guía | 1 | 1 |
El mensaje fue votado negativamente | 6 | -36 |
Votó negativamente un mensaje | 20 | -40 |
Don is correct that tapping the hole as it exists won't really work and offered some viable solutions. However, if there isn't enough material for a Helicoil to bite into it won't work either on a through hole and sometimes using a larger bolt isn't an option either. In such cases you can add some filler to your existing hole. JB Weld can work as a filler for aluminum. If you apply a thin enough coating, you can tap the hole after it cures without drilling - then use a Helicoil for strength. Option 2 would be to use an aluminum filler rod and a MIG welder to fill, then drill and tap the hole.
If the nail polish is just thick, you can run hot water over the bottle for a few minutes to thin it down some. You don't want to shake a bottle of nail polish to mix it, it can put air bubbles in the mixture, instead roll the bottle between your hands. Nice first guide, GL here.
Alba this is the wrong area to post this. Please ask your question here: http://www.ifixit.com/Answers/