Professional Apple tech since 2014
Ayuda
jeremyfitz
jeremyfitz
| 1,814 | Reputación |
| 6 | Soluciones |
| 1 | Guía |
| Miembro Desde 12/02/14 | |
Votos
9
0
| 1,814 | Reputación |
| 6 | Soluciones |
| 1 | Guía |
| Miembro Desde 12/02/14 | |
Professional Apple tech since 2014
| Evento | Recuento | Delta |
|---|---|---|
| Alguien completó tu guía | 40 | 960 |
| Tradujiste una guía | 11 | 560 |
| Un administrador aprobó tu guía | 1 | 120 |
| A alguien le gustó tu guía | 10 | 91 |
| El mensaje fue votado positivamente | 6 | 72 |
| Edición patrullada al aceptar el paso de guía | 13 | 13 |
| Edición patrullada a introducción de la guía aceptada | 2 | 2 |
| Edición patrullada al wiki aceptada | 1 | 1 |
| El mensaje fue votado negativamente | 1 | -6 |
You’re right! I used a previous guide that shows up until the camera is removed, then my own starts after I’ve already removed this flexible metal bracket. This bracket is used as a alignment guide and stabilizer for the camera so hard hits don’t rattle the sensitive internal magnets that stabilize the camera lenses. With a fine screwdriver, pop the 4 points that this is welded to the lens up then remove the bracket. It may get mangled a bit but it can usually be straightened back out to re-use upon camera reinstall.
Having this tear-down showing a significant improvement in redesign, I’d cop one of these for sure. Not the i9, but an i7 with 16gb is more than enough for me. Thanks for the quaity post and for your sponsorship of the right-to-repair movement!
You need to follow this guide, then press down on the ring from the inside and tap it out gently. Then replace the ring.