joe

I have 2 damaged ipods that a customer has requested for me to retrieve her songs. I have tried many options and I cannot...

heres a screw mat here thats all i can find...

charge the controller or put in fresh batteries, unplug the xbox, wait 30 seconds, plug it back in then test it by turning on the console then turn on the controller.

Before you all go fiddling with complicated calibration settings, try this simple solution with an old toothbrush: Use a card or fingernail to slightly lift the screen bezel around the touch screen, only needs to be just enough to get a few toothbrush bristles under it. Work the brush bristles gradually right around the screen and note what drops out on a clean sheet of paper. A few grains of sand / grit is enough to screw up your screen sensitivity. Better yet, blast air under the bezel as you lift it. Use a can of air (as used for cleaning photographic lenses) with a fine nozzle attached. if this does not work this is a link to a document which shows how to calibrate the tomtom screen for a certain model. English: http://www.martin-kolinsky.com/freeinstructionsfordownload...-Touch%20screen%20calibration.pdf and if this does not work... First create a backup of your gps with windows explorer using the procedures in this link.This is important in protecting your map data which if you lose you may have to...

How do you reset the ring doorbell? If the light still doesn't start spinning when you push the orange button, try performing a hard reset. To perform a hard reset, hold down the black button for 15 seconds. After releasing it, the light on the front will flash a few times indicating that your Ring Doorbell is restarting then re start the setup process all over again. Ring setup video

If you cannot see the drive then you cannot format the drive. You should run diagnostics by holding down d during startup. Most likely you have a failed ssd and it will most likely need to be replaced.

I have had good luck with most of the keyboards on amazon. I have received a dud or two but for the most part I have gotten good quality parts. I haven't had any keyboards fail after installing them I just got a couple one time that had sticking keys. Just make sure you use amazon prime so it makes it easier to return if necessary.

Hold during startup Shift (⇧) Start up in safe mode. Option (⌥) Start up to Startup Manager, which allows you to choose other startup disks, if available. If your Mac is using a firmware password, you're asked to enter the password first. D Start up from the built-in Apple Hardware Test or Apple Diagnostics utility, depending on your Mac model. Or use Option-D to start up from this utility over the Internet. N Start up from a compatible NetBoot server, if available. To use the default boot image on the NetBoot server, hold down Option-N instead. iMac Pro doesn't support this startup key. Command-R Start up from the built-in macOS Recovery system. Or use Option-Command-R or Shift- Option-Command-R to start up from macOS Recovery over the Internet. macOS Recovery installs different versions of macOS, depending on the key combination you use while starting up. Option-Command (⌘)-P-R Reset NVRAM (or PRAM). If your Mac is using a firmware password, this combination causes your Mac to start up from macOS...

unplug printer power cord from back of printer, hold down power button for 10 seconds. Plug printer back in . power up printer

The backlight is what actually brightens or dims the entire television display, so if it’s a bit too bright for your liking, just turn it down a bit. And if it’s not bright enough, crank it up to a level that’s suitable. However, make sure to leave the “brightness” alone unless you’re re-calibrating your TV’s picture. For day-to-day adjustments, backlight is what you want.

Delete the printer and reinstall the printer drivers. Download updated drivers by entering the model number on the manufacturers website.