Rep: 1
1
Hello,
I get a f06 code on the washer when I run a complete wash cycle. I can usually run a rinse and drain cycle. I read the f06 post and tried unplugging and replugging various connectors on the CCU and MCU. I suspect a failing part, possibly a speed or rotation sensor. Where are these sensors?
Es esta una buena pregunta?
Rep: 463.4mil
11
374
1.5mil
Hi @mron
There is no balance sensor in the washer. At least there's none shown in the parts list for the washer.
Intermittent problems can be hard to find so perhaps try checking the connections between the MCU and the drive motor to see if they're all OK i.e. not loose, corroded etc.
Here's the tech sheet for the washer that may also help. On p.8 it describes how to check the windings for the motor, just in case one winding is not within spec or is on the limit of what may be acceptable to the MCU.
Fue útil esta respuesta?
The tech sheet is very helpful! thanks
Ultimas 24 horas: 0
Ultimos 7 días: 0
Ultimos 30 días: 14
Todo El Tiempo: 75
Hi @mron,
What is the model number of the washer?
- de jayeff
It's an elite quiet pack 4
- de Ron Moreland
@mron
The model number would help to ensure that if parts are required that the correct part can be found.
- de jayeff
110 45972400
- de Ron Moreland
110 45972400
- de Ron Moreland
Mostrar 4 comentarios más