Repara tus cosas Comunidad Tienda

Repair guides for all Carrier furnaces, air conditioners, and more.

Preguntas 2 Ver todo

Opciones

Help understanding my Carrier Weathermaker 9200.

I have 2. One upflow, the other downflow. Upflow works great, using it for comparison.

Downflow max temp at floor vent is 70 degrees- varies a couple degrees from vent to vent). (Upflow vents are around 90 degrees)

I can see blue flame at the “sight portal”. There is/was a smell similar to burnt resistor in the house. Checked furnace areas easily accessible to me for source found none. Fan runs

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 0
1 comentario

This question was migrated from https://meta.ifixit.com/Answers.

- de

Agregar un comentario

1 Respuesta

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Respuesta Más Útil

Opciones

Hi @d544

Not sure if this information is relevant to your particular model variant (58MCA and 58MXA) but check if there is a LED fault code display on the control board or if not if there is any obvious component damage on the board at all. (see p.9-10 on the document linked).

What is the full model number of the unit? Perhaps check if there is a product info label on the unit somewhere (on the back?) rather than the brand/model name on the front.

Knowing the correct model number will help to find the correct spare parts if there is a faulty part that needs replacing.

Fue útil esta respuesta?

Sí No
Puntuación 2

1 comentario:

Couldn’t wait. Called for service. After working on it for 3 hours, cleaning, looking at input gas pressure, igniters, valve, etc. , using camera to look at heat exchanger, saw rusted section, determined and recommended either new heat exchaner or complete new unit.

Thank you jayeff for your response.

- de

Agregar un comentario

Añadir tu respuesta

Doug Shuberg estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 2

Todo El Tiempo: 221