Rep: 13
3
1
Does anyone own the schematics of the iPad 12.9”?
I would need them to repair the touch filter
OK following things are broken the touch filter is burnt and the solder lines too, I’m searching for a point to put a jumper. Does anyone have experience with that
Es esta una buena pregunta?
Rep: 4.8mil
11
5
1
hello Expolosions&,
those don't exist. All we use is knowledge and experience in electronics gained through years of work.
I would use 120ohm/450mA circ.20%. If it can't stand it change on 240ohm / 350mA circ.20%. That’s all.
hello Explosions &…
its absolutely 240/350mA 0201 coil in VDD_screen line, connected to 3 near connector pins and small capacitor right. The other side goes straight to 8566 backlight ic (see picture).
Fue útil esta respuesta?
I think you got it wrong my problem is that the solder line is completely burnt and I need to find a pout to put a jumper wire
brother, touch function has no filter coils on circuit in that model. Directly to touch controllers (there are two). Interface is closed inside metal bracket (big one) on screen flex. I guess the burned lines are near the connector. Submit a photo - I'll explain.
Ultimas 24 horas: 2
Ultimos 7 días: 15
Ultimos 30 días: 60
Todo El Tiempo: 1,131
3 comentarios
Desmontaje iPad Pro 12.9 "
Are you talking about this, or what do you mean specifically?
- de SparkWorx
I meant from the circuit because the Filter for touch is completely burned and the solder line and no one knows where to put a jumper wire
- de Explosions & Explosions
brother, touch function has no filter coils on circuit in that model. Directly to touch controllers (there are two). Interface is closed inside metal bracket (big one) on screen flex. I guess the burned lines are near the connector. Submit a photo - I'll explain.
- de bert.harmidomski