Saltar al contenido principal

Procesador Intel Core i5 de doble núcleo a 2,5 GHz (Turbo Boost de hasta 3,1 GHz) con 3 MB de caché L3 compartida.

Preguntas 266 Ver todo

No WiFi or Bluetooth after replacing battery and speakers

I’m not sure where to begin looking for the problem. Can someone point me in the right direction? I have no Wi-Fi or Bluetooth after replacing the battery and speakers on my MacBook Pro 13 inch retina late 2012 laptop. I followed the tutorial exactly and did not seem to have any problems during the repair.

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 0
Agregar un comentario

2 Respuestas

Respuesta Más Útil

Either the I/O board cable or the I/O board its self has an issue

MacBook Pro 13" Retina (Late 2012-Early 2013) I/O Board Data Cable

MacBook Pro 13" Retina (Late 2012-Early 2013) Right I/O Board

Here’s the guide MacBook Pro 13" Retina Display Late 2012 I/O Board Replacement

Imagen de MacBook Pro 13" Retina (Late 2012-Early 2013) Right I/O Board

Producto

MacBook Pro 13" Retina (Late 2012-Early 2013) Right I/O Board

$49.99

Imagen de MacBook Pro 13" Retina (Late 2012-Early 2013) I/O Board Data Cable

Producto

MacBook Pro 13" Retina (Late 2012-Early 2013) I/O Board Data Cable

$4.99

Fue útil esta respuesta?

Puntuación 1

3 comentarios:

I’m an amateur here so I really appreciate your time. I made sure all cables were reconnected properly. In your opinion should I proceed with replacement of the recommended items? I was extremely careful when I replaced the battery so I don’t think I damaged anything. Are there any other things I should check first? The only other ‘symptom’ before I replaced the battery was occasional difficulty getting the laptop to connect to a Bluetooth speaker. It would sometimes take multiple attempts to connect with no apparent cause. Thanks again.

- de

Try reseating the I/O cable, if that fails replace it and test again.

- de

Will do thanks!

- de

Agregar un comentario

I’m having this same issue. Did you solve it in the end?

Fue útil esta respuesta?

Puntuación 0

1 comentario:

@henrychugh26 - Did you try resetting the cable and if that didn’t help replace the cable. 40% of the time reseating fixes it and the other 40% replacing is needed. And lastly 20% the board is corroded up.

- de

Agregar un comentario

Añadir tu respuesta

Angela Desjardins estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 8

Todo El Tiempo: 547