Repara tus cosas Comunidad Tienda

Cuarta generación de CDMA iPad 4. Disponible en modelos de 16, 32 o 64 GB. Número de modelo A1460.

Preguntas 20 Ver todo

Opciones

Help! I can not find the connector for the home button iPad4

Dear All,

Please help me solve a small mystery. My daughter broke the glass of her screen of her iPad4. I decided to replace it, and all went until I have to place the flat cable of the home button in the connector. There is not a connecter … I checked Youtube movies and images, and I checked my table if it may be dropped, but none of this seems the case. Please find attached pictures.

Many thanks,

Wiz

Block Image

Block Image

Block Image

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 0
1 comentario

Really kind of you to reply. Thank you so much!

- de

Agregar un comentario

3 Respuestas

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Solución Elegida

Opciones

The problem is that you are trying to install a replacement digitizer that is supposed to be for the iPad 4 instead of the iPad 3 one which you should be using.

Basically what you’ll need to do is remove the two screws under the home button on the old screen. Remove the little home button (HB) board from that.

Then remove the two screws at that same spot on the replacement digitizer which has the HB with the cable coming out of it.

Take the board out of that one and use the HB board from the old screen then put the two screws in. Now the HB will work.

TL:DR Can’t use Home Button on a replacement iPad 4 digitizer (as the HB has a cable) on a iPad 3 which you have, need to transfer the HB board from old digitizer.

Fue útil esta respuesta?

Sí No
Puntuación 3

2 comentarios:

Really helpful, thank you so much!

- de

Thanks Ben, that was the solution. It works perfectly now.

- de

Agregar un comentario

Opciones

Block Image

Those 4 pads next to antena conector supposed to be your button conector..

Check inside cause it fell…

Fue útil esta respuesta?

Sí No
Puntuación 0
Agregar un comentario

Opciones

The home button connector is in the bottom picture. It uses a ribbon style connector, you slide it in and flip the lever to lock it in place then tape it down.

Fue útil esta respuesta?

Sí No
Puntuación 0
Agregar un comentario

Añadir tu respuesta

Wiz estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 63