Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

A programmable brewing machine by Keurig. This coffee maker uses K-Cup Pods and K-Carafe Pods to brew a variety of hot and cold drinks. Model Number: K2.0-400 Serial Number: 401.0200.1410931

Preguntas 38 Ver todo

What is this tiny silicon rubber part?

I was cleaning my K400 this morning and pulled out the pod holder and the tray below that. This part was in the tray (pen shown for scale). I would guess it goes over one of the needles? Which way is up?

Block Image

Block Image

Contestado! View the answer Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 2

Comentarios:

Hi, same exact thing happened to me today while cleaning my Keurig. Did anyone figure out where this tiny piece goes???

- de

Nope, I'm guessing it goes over on of the upper needles, but not sure which one or wich way up. I might just try all possibilities.

- de

Well, I was going to post a photo of where this goes (to answer my own question & whomever else may need this info as well), but I don’t seem to have the ability to attach a photo.

Simply put, it goes on the needle head that the coffee pod sits on. I believe this little silicone/rubber piece acts as a cushion, holding the coffee pod in place & preventing the grounds from coming out. Slip it on the “needle head” so that the larger end is on the bottom.

- de

Same problem a few days ago. Keurig sent me a replacement cup holder at no charge, priority mail (after trying to sell me a new unit). The piece slides over the bottom needle of the cup holder. The larger circle/end of the rubber sleeve was on top.

- de

Looks like bottom needle with the big end up! Thank you "Name"! If you would be so kind as to add your comment as an answer I'll accept it.

- de

Mostrar 8 comentarios más

Agregar un comentario

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

SALTEA LA ACTUALIZACIÓN

Ahorra reparando con un kit todo en uno.

Compra Kits de Reparación

2 Respuestas

Solución Elegida

I experienced the same issue recently. Keurig customer service could not provide an answer, because the model has been discontinued. They did, however, send me a replacement K-cup holder via priority mail. Upon my inspection of the new cup holder, I observed the silicone piece situated over the needle located inside and on the bottom of the cup holder. The larger circular end of this sleeve was closest to the top of the needle.

Fue útil esta respuesta?

Puntuación 2

Comentarios:

Thank you! Same problem, this was a super easy fix now that I know where it goes. :)

- de

Agregar un comentario

Kevin Hollingshead  appears to be the seal around the puncture needle. Take a look on here Como limpiar y abrir una cafetera Keurig at Step 2. Different model same idea.

Fue útil esta respuesta?

Puntuación 1

Comentarios:

Thanks, Mr. O, but the bottom needle seems to be too short. But thanks for the indirect tip to find cleaning vids/guides. Keurigs parts support sucks. A nice exploded view would help.

- de

My kurig will not poke a large enough hole and water and grounds overflow! I have cleaned it and ordered a new pod holder/needle and still same issue???

- de

Agregar un comentario

Añadir tu respuesta

Kevin Hollingshead estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 26

Ultimos 7 días: 151

Ultimos 30 días: 661

Todo El Tiempo: 4,809