Repara tus cosas Comunidad Tienda

iPhone de 4 pulgadas lanzado en marzo de 2016 con especificaciones de hardware similares al 6s. Disponible en Plata, Gris espacial, Oro u Oro rosa con opciones de almacenamiento de 16/64 GB. Modelos A1662 y A1723.

Preguntas 1049 Ver todo

Opciones

Rebooting after battery replacement

Hey,

I replaced the battery of an iPhone SE about two weeks ago. The iPhone worked great after replacement. But now, after two weeks of use, the iPhone wont boot to homescreen. Its stuck at the Apple logo.

What Ive down to repair it: I have set the iPhone in recovery mode and tried to reload and install iOS 12. But now the iPhone starts, display shows the Apple logo, turns off, and starts again. I also tried older os versions but still the same.

Can anyone help? Could the new battery be the problem?

Thank you!

Christian

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 0
1 comentario

test the battery, use a multi-meter and connect to battery, if the reading drops quickly it is the battery, V reading should hold for a bit if it is good. Try another battery.

- de

Agregar un comentario

1 Respuesta

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Solución Elegida

Opciones

I would certainly suspect the battery, it is the weakest link in the chain.

If you still have your old battery and it still worked, I would try installing it to see if the problem goes away. If you have access to a multimeter, you could also measure the voltage directly on the replacement battery to see if it is charged or not. A phone should boot with a battery as low as 3.2V, maybe even a bit less. If you have less than 3V, then either your battery is bad or there is an issue with the charge circuit (cable, brick or logic board).

Fue útil esta respuesta?

Sí No
Puntuación 2
Agregar un comentario

Añadir tu respuesta

Christian estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 2

Ultimos 30 días: 3

Todo El Tiempo: 104