Repara tus cosas Comunidad Tienda

La más grande de las computadoras portátiles MacBook Air de Apple con micrófonos duales y conectividad Wi-Fi 802.11ac.

Preguntas 465 Ver todo

Opciones

A couple drops of water and my screen is dim?

Mid 2013 MacBook air. Got a few drops of water around the delete key and now the screen is dim. It appeared to be out but when I shine a light on it I can see a bit so it’s still working, just dark. Hooked up to a monitor right now and working fine, just not portable. I’ve seen other posts on this but no real solutions that I can find. Fairly handy so I’m happy to get out the tools. Much obliged for the assistance.

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 0
Agregar un comentario

2 Respuestas

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Respuesta Más Útil

Opciones

@mikehalker

it is most likely dry but it may already have caused corrosion. You will have to start disassembling it and take a look at what you got going on. The very first thing, once it is apart, would be to check the connector for corrosion, check for obviously damaged components and check the backlight fuse. Use this guide Reemplazo de la placa lógica del MacBook Air 13" Mid 2013 to work on it and this guide Agregar imágenes a una pregunta existente to post some good pictures of your board and teh dispaly connector.

Imagen de MacBook Air 13" Mid 2013 Placa Lógica

Guía

Reemplazo de la placa lógica del MacBook Air 13" Mid 2013

Dificultad:

Moderado

—

2 hours
Imagen de iFixit

Guía

Agregar imágenes a una pregunta existente

Dificultad:

Muy fácil

—

2 - 5 minutes

Fue útil esta respuesta?

Sí No
Puntuación 2

1 comentario:

Checked the backlight fuse. It ohms out fine. No Corrosion anywhere and the logic board looks fine. Checked all connections. As I said, I can see the screen on when I shine a light on it. Also, the apple doesn't light up on the back anymore.

- de

Agregar un comentario

Opciones

Is it dark like the screen brightness is turned down to its lowest setting or is it completely dark like the backlight isn’t coming on at all? If it is completely dark then I would suspect that some water made it to the logic board. If the screen is lit up dimly, like the screen brightness is all the way down, it is possible that the F1 key got some moisture in it and is stuck. Seeing as how you said that the water was spilled near the delete key and that is where the screen LVDS connector is located, I’m guessing some water made its way to the logic board. I would say disassembly and drying is the first step.

Fue útil esta respuesta?

Sí No
Puntuación 0

1 comentario:

It’s dark like you have to shine a flashlight on it to see anything. It’s been about a month of using it so I would think it would be dry by now. It is my first time though so maybe not.

- de

Agregar un comentario

Añadir tu respuesta

Mike Halker estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 122