RESUELTO:Does anyone think this could be what is causing Touch ID to fail? - iPhone 6 Plus

Does anyone think this could be what is causing Touch ID to fail?

The "gunk" I have circled in this picture of the home button here is the only thing I can find that looks wrong with the Home Button and It's Connector to the Shield Plate on the back of the LCD. Everything looks perfectly fine except for this connector on the logic board. Thoughts?

also if you do think this is the problem how would I go about removing this? Isopropyl Alcohol?

Thanks for any help!

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No

Puntuación 0

Publicado: 23 de ene. de 2018

Opciones

I would use very fine tweezers and be very careful taking it off to avoid damaging the connector.

Better to try isopropyl alcohol and brush first. And yeah the two pins are blocking the connection to the home button extension cable so it's probably stopping touch ID from working.

Fue útil esta respuesta?

Sí No

Puntuación 2

1 comentario:

Used isopropyl to clean it! Didn't have any tweezers small enough (that didn't have flux on them) to try to get it out with. A brush and some isopropyl did the trick to get it off and Touch ID has been restored. Thanks for the answer my friend!

23 de ene. de 2018 - de Cole Walker

Agregar un comentario

iPhone 6 Plus

Does anyone think this could be what is causing Touch ID to fail?

1 Respuesta

Añadir tu respuesta