Saltar al contenido principal

Little part fell off the JBL flip 3 motherboard labeled 1R5

I dropped my JBL flip 3 speaker the other day and I started to hear a rattle inside so I decided to take it apart and see what it was and it was a small box at the top Corner of the motherboard labeled 1R5 and i don't know how to put it back on

Contesta esta pregunta Yo también tengo este problema

Es esta una buena pregunta?

Puntuación 2

2 comentarios:

Exact same problem has happened to me, does anyone have a solution

- de

the same excact thing happened to me

- de

Agregar un comentario

3 Respuestas

@mtz13 without actually seeing what is going on, it is difficult to answer. Consider posting some picture of your board with your question. Use this guide Agregar imágenes a una pregunta existente for that. The 1R5 sounds like a fixed 1.5uH inductor. Again without seeing it, this is only an assumption. Those are usually soldered to the board and there is not other way reattach it.

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Something similar happened to me. The 1R5 piece didn't break down fully and now one contact is lose. I think the only way is to solder it down. https://imgur.com/a/2y4Xy

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

I had the same problem and solved it by cutting a wine cork in size to press the 1R5 piece against the contact. Good luck

Fue útil esta respuesta?

Puntuación 0
Agregar un comentario

Añadir tu respuesta

Joe estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 13

Todo El Tiempo: 1,497