Repara tus cosas Comunidad Tienda

Pantalla de 7.9 pulgadas / Modelo A1432 / Disponible en blanco o negro / Anunciado el 23 de octubre de 2012/16, 32 o 64 GB de capacidad

Preguntas 220 Ver todo

Opciones

Lcd half dead after digitizer replacement, can someone help me?

Hello everybody!

I just tried to fix my iPad mini after my father broke the digitizer.

So....where do I start??

  • First time I do this kind of operation, purchased all the items from the iFixit store in EU besides the digitizer which was not available.
  • Removed the broken digitizer (that was messy...glass shattered everywhere!)
  • Removed the lcd and shield plate
  • Disconnected broken digitizer, lcd and battery
  • Cleaned up everything
  • Connected the new digitizer, lcd and battery
  • Tested the iPad to see if everything was working
  • PROBLEM!

Block Image

Block Image

There is no backlight but you can see the icons on the lcd, the problem is that the left half of the screen is dead!

I tried to disconnect and re-connect the lcd again but nothing changed, have I damaged something while I was removing the lcd??

Please find attached some photos of the lcd

Contestado! Ver respuesta Yo también tengo este problema

Es esta una buena pregunta?

Sí No
Puntuación 0
Agregar un comentario

2 Respuestas

Filtrar por:
Mas Útiles Más Reciente Más antiguo
Solución Elegida

Opciones

You have two common problems.

1.) You removed the LCD connection before removing the battery. This will blow the highly sensitive iPad mini backlight fuse. It will have to be replaced. I highly recommend sending it out for a simple inexpensive fuse replacement rather than reading up on the all the ways to jump the fuse, it is in an area surrounded by critical components---way too easy to do irreversible damage

2.) You damaged the LCD itself during removal. This is very common with the thin LCD on the mini, and can often occur just from flexing the LCD during removal, or from failure to cut through the bottom tape--too much pressure on the LCD.

You will need a new LCD and a fuse replacement to solve.

jessa

Fue útil esta respuesta?

Sí No
Puntuación 2

1 comentario:

For the LCD you were right, I damaged it while I was removing it.

For the backlight everything fixed by itself, the following day the backlight was working ok, even with the damaged LCD.

Today I installed a new LCD and now it's everything is good.

Thanks for the support.

Cheers

- de

Agregar un comentario

Opciones

Breaking the lcd is a problem when removing as it's glued down had you any difficulty removing it?

Fue útil esta respuesta?

Sí No
Puntuación 0

1 comentario:

No, there was no difficulty

- de

Agregar un comentario

Añadir tu respuesta

csk34 estará eternamente agradecido.
Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 404