Rep: 1
1
3
My factory power supply is fine. POS ex wife tripped over the thing so many times the barrel-connector at the end finally wore out right at the connection. i'm on a tight budget and can solder another on if there's a replacement available (pref with wire leads in place). do you guys have any idea where to run one down?
Es esta una buena pregunta?
Rep: 35.1mil
140
71
53
The easiest way would be replacing the dc-in board:
[producto vinculado inexistente o deshabilitado: IF155-065]
depending on your soldering skills and the the condition it might be possible to solder the old one in - if that won't work - maybe you should search the part on ebay
and btw - i hope you meant "princess of sheba" with POS ;-)
Fue útil esta respuesta?
Haha....no, I meant what you think. I think 1/2 the time she did it on purpose! ;-)
I think you misunderstand, I mean just the little lighted barrel-gonnector on the end of the power adapter. I broke free from the wiring and the connection is bad somewhere in the little chip set that makes it light up. Surely....lots of folks have had this happen....hence, the mag-safe stuff on the MacBooks, huh?
Thanks Markus,
Matt
ok, now i get it ;-) here is a guide to repair the connector: http://www.instructables.com/id/Repair-y...
+ Ralph
Ultimas 24 horas: 1
Ultimos 7 días: 4
Ultimos 30 días: 7
Todo El Tiempo: 1,734
1 comentario
Haha....no, I meant what you think. I think 1/2 the time she did it on purpose! ;-) I think you misunderstand, I mean just the little lighted barrel-gonnector on the end of the power adapter. I broke free from the wiring and the connection is bad somewhere in the little chip set that makes it light up. Surely....lots of folks have had this happen....hence, the mag-safe stuff on the MacBooks, huh?
So, any idea where to get that type of barrel-connector that I can splice onto the end of the power adapter?
Thanks Markus, Matt
- de matt lauter