Rep: 625
7
3
2
I built a charger with a 5v regulator and hard wired it to the regulator. The regulator shorted out and killed my phone, it wont charge anymore. If I turn it on it runs for maybe one minute and then shuts down. Any way, my question is if I replace the dock connector will it fix the problem, or do I just need to buy a new phone?
Es esta una buena pregunta?
Rep: 784.3mil
1.1mil
894
2.3mil
John Laney, there is a reversed voltage protection, but I can not see an overload protection. I would start by replacing the dock connector. While you do that, visually check your components on the board. Look for any signs of burned, charred or missing components. Be aware that if you have to perform any repair on your board, it will involve very small components that require good tools and great skills to repair.
Fue útil esta respuesta?
Rep: 625
7
3
2
Just replaced the dock connector, didn't fix the problem. I also looked for signs of charring on the board, none to be found on the visible side. I'm afraide I just need to buy a new phone :(
Anyway thanks for the advice.
Fue útil esta respuesta?
Replace battery.
did that too, didn't affect it. Bought a new 5s. Thanks for the help anyway.
Ultimas 24 horas: 0
Ultimos 7 días: 4
Ultimos 30 días: 10
Todo El Tiempo: 717
