断开主板连接

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará la guía que incluye este paso.

Inglés

Chino

Traduciendo paso 13

Paso 13

Repeat the previous step for the other corner until the entire cable is disconnected.
Lift up the cable and peel off any remaining coating holding it to the motherboard.
During reassembly:
Inspect the ends of the cable and the ZIF connectors for any remaining coating that could prevent a good connection.
Peel off the coating, heating the cable and the ZIF connector when the coating becomes too brittle.
It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in the connector.

对另一个角重复上一步，直到整个排线断开连接。
提起排线并剥掉将其固定在主板上的所有剩余涂层。
重新组装期间：
检查排线两端和 ZIF 接口是否有任何残留涂层，以免影响连接。
剥离涂层，在涂层变得太脆时加热排线和 ZIF 接口。
不必力求完美！ 您只需去除足够的涂层即可将排线正确固定在接口中。

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.