Saltar al contenido principal

Motherboard abtrennen

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará la guía que incluye este paso.

Inglés
Alemán
Paso 6
Motherboard Disconnection: paso 0, imagen 1 de 3 Motherboard Disconnection: paso 0, imagen 2 de 3 Motherboard Disconnection: paso 0, imagen 3 de 3
  • Because of the awkward angle, this step requires some patience to avoid tearing the cables. Work slowly and apply heat regularly.

  • Use blunt nose tweezers to pull the cables away from their ZIF connectors slowly and steadily at a level angle to separate the coating.

  • Gripping the tweezers closer to the tip can help get a tighter hold on the cables.

  • Keep pulling on the cables until they're completely disconnected.

  • During reassembly:

  • Inspect the ends of the cables and the ZIF connectors for any remaining coating that could prevent a good connection.

  • Peel off the coating, heating the cable and the ZIF connectors when the coating becomes too brittle.

  • It doesn't have to look pretty! You just need to remove enough coating to have the cables sit properly in their connectors.

Wegen des ungünstigen Winkels erfordert dieser Schritt etwas Geduld, damit die Kabel nicht reißen. Arbeite langsam und wende regelmäßig Wärme an.

Benutze eine stumpfe Pinzette, um die Kabel langsam und gleichmäßig in einem ebenmässigen Winkel von ihren ZIF-Steckverbindern wegzuziehen und die Beschichtung abzulösen.

Wenn du die Pinzette näher an der Spitze greifst, kannst du die Kabel besser festhalten.

Ziehe weiter an den Kabeln, bis sie vollständig abgetrennt sind.

Achte beim Wiederzusammenbau auf folgende Punkte:

Prüfe die Kabelenden und die ZIF-Stecker auf eventuelle Beschichtungsreste, die eine gute Verbindung verhindern könnten.

Ziehe die Beschichtung ab, erwärme das Kabel und die ZIF-Stecker, wenn die Beschichtung zu spröde wird.

Es muss nicht schön aussehen! Du musst nur so viel Beschichtung entfernen, dass die Kabel richtig in ihren Steckern sitzen.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.