屏幕（总成）的拆卸

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 10 guías que incluyen este paso.

Inglés

Chino

Traduciendo paso 3

Paso 3

Insert an opening pick

Once the screen is warm to touch, apply a suction handle to the bottom edge of the screen and as close to the edge as possible.
Lift the screen with the suction handle to create a small gap between the screen and the frame.
Insert an opening pick into the gap between the frame and the screen.
Don't insert the pick more than 1.5 mm to avoid damaging the circuit board.
Leave the opening pick in place to prevent the adhesive from resealing.

翘入边缘并拿出屏幕

一旦屏幕加热到了合适的温度，即可使用塑料吸盘贴合到屏幕的边缘处（尽可能靠近边缘）。
轻轻用力拔起屏幕使其与金属中框之间产生一个小间隙。
再向这个间隙里放置一块塑料撬片或者是其它扁状钝器。
请注意！！！撬片插入的深度切勿超过1.5mm以免损坏电路板。
然后将撬片停留在原位放在粘合剂重新凝固。

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.