iMac 2009-2010 SSD Replacement

Aviso: Estás editando una guía de requisitos previos. Cualquier cambio que realices afectará a todas las 4 guías que incluyen este paso.

Volver a la Guía

Inglés

Coreano

Traduciendo paso 10

Paso 10

iMac 2009-2010 SSD Replacement: paso 0, imagen 1 de 3

iMac 2009-2010 SSD Replacement: paso 0, imagen 2 de 3

iMac 2009-2010 SSD Replacement: paso 0, imagen 3 de 3

If your motherboard has a socket for a hard drive temperature sensor, follow this step to plug the sensor wires in.
Find the connector on the motherboard labeled HD TMP or HDD TEMP.
If you have trouble locating it, trace the two-wire temperature cable you disconnected from the old hard drive.
If the previous temperature cable is still connected to the board here, disconnect and remove it. You will no longer need it.
Connect the temperature sensor's two-wire red-black cable to the motherboard plug labeled HD TMP or HDD TEMP.
The connector is keyed to fit in only one orientation. If it doesn't fit one way, rotate it 180° and try again.
Route the excess wire so it does not interfere with any other components.

Tus contribuciones son autorizadas bajo la licencia de código abierto de Creative Commons.