Saltar al contenido principal

Introducción

prerequisite

  1. Use the tip of a spudger to peel back a small piece of tape covering a screw on the left side of the headphone jack.
    • Use the tip of a spudger to peel back a small piece of tape covering a screw on the left side of the headphone jack.

  2. Remove the following screws securing the headphone jack, Lightning connector, and speaker.
    • Remove the following screws securing the headphone jack, Lightning connector, and speaker.

    • Three 2.6 mm #000 Phillips screws

    • Two 2.0 mm #000 Phillips screws

  3. Use the flat end of a spudger to pry the speaker up from the rear case.
    • Use the flat end of a spudger to pry the speaker up from the rear case.

    • Do not try to remove the speaker, as it is soldered to the Lightning connector assembly.

  4. Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case. Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.
    • Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

iFixit Miembro de iFixit

Community

136 Miembros

16,058 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 174